Connecting Dc Power To Des-3828Dc - D-Link xStack DES-3800 Series User Manual

out of the rack on its slide assemblies at one time. The weight of more than one
extended component could cause the rack to tip over and may result in injury.
Power On AC Power
Plug one end of the AC power cord into the power connector of the Switch and the other end into the
local power source outlet.
After the Switch is powered on, the LED indicators will momentarily blink. This blinking of the LED
indicators represents a reset of the system.
Power Failure
For AC power supply units, as a precaution, in the event of a power failure, unplug the Switch. When
power is resumed, plug the Switch back in.

Connecting DC Power to DES-3828DC

Follow the instructions below to connect the DC power supply of the DES-3828DC to the DC power
source.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Figure 2 - 3. Installing Switch in a rack
10