Layer 3 Features; Ip Interface Settings - D-Link xStack DES-3800 Series User Manual

Layer 3 Features

IP Interface Settings

MD5 Key Settings
Route Redistribution Settings
Static/Dynamic Route Setings
Route Preference Settings
Static ARP Settings
RIP
OSPF
DCHP/BOOTP Relay
DNS Relay
VRRP
IP Multicast Routing Settings
The following section will aid the user in configuring security functions for the Switch. The Switch
includes various functions for IP Interface Settings, MD5 Key Settings, Route Redistribution Settings,
Static/Dynamic Route Setings, Route Preference Settings, Static ARP Settings, RIP, OSPF,
DCHP/BOOTP Relay, DNS Relay, VRRP, and IP Multicast Routing Settingsall discussed in detail in
the following section.
IP Interface Settings
Each VLAN must be configured prior to setting up the VLAN's corresponding IP interface.
An example is presented below:
In this case, six IP interfaces are required, so a CIDR notation of 10.32.0.0/11 (or a 11-bit) addressing
scheme will work. This addressing scheme will give a subnet mask of
11111111.11100000.00000000.00000000 (binary) or 255.224.0.0 (decimal).
Using a 10.xxx.xxx.xxx IP address notation, the above example would give 6 network addresses and 6
subnets. Any IP address from the allowed range of IP addresses for each subnet can be chosen as an IP
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
VLAN Name
System (default)
Engineer
Marketing
Finance
Sales
Backbone
Table 8- 1. VLAN Example - Assigned Ports
VID Switch Ports
1 5, 6, 7, 8, 21, 22, 23, 24
2 9, 10, 11, 12
3 13, 14, 15, 16
4 17, 18, 19, 20
5 1, 2, 3, 4
6 25, 26
103
Section 8