Static/Default Route Settings - D-Link xStack DES-3800 Series User Manual

Click Add/Modify to implement changes made.

Static/Default Route Settings

Entries into the Switch's forwarding table can be made using both MAC addresses and IP addresses.
Static IP forwarding is accomplished by the entry of an IP address into the Switch's Static IP Routing
Table. To view the following window, click Layer 3 Features > Static/Default Route Settings.
This window shows the following values:
Parameter
IP Address
Subnet Mask
Gateway
Metric
Protocol
Backup State
Delete
To enter an IP Interface into the Switch's Static/Default Route Settings window, click the Add
button, revealing the following window to configure.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
RIP routing protocol. The user may specify a cost between 0 and 16.
NOTE: The source protocol (Src. Protocol) entry and the
destination protocol (Dst. Protocol) entry cannot be the
same.
Figure 8- 6. Static/Default Route Settings window
Description
The IP address of the Static/Default Route.
The corresponding Subnet Mask of the IP address entered into the table.
The corresponding Gateway of the IP address entered into the table.
Represents the metric value of the IP interface entered into the table. This field may
read a number between 1-65535 for an OSPF setting, and 1-16 for a RIP setting.
Represents the protocol used for the Routing Table entry of the IP interface. This field
may read OSPF, RIP, Static or Local.
Represents the Backup state that this IP interface is configured for. This field may read
Primary or Backup.
Click the if you would like to delete this entry from the Static/Default Route
Settings table.
108