Virtual Links - D-Link xStack DES-3800 Series User Manual

Virtual Links

Virtual links accomplish two purposes:
Linking an area that does not have a physical connection to the backbone.
•
Patching the backbone in case there is a discontinuity in area 0.
•
Areas Not Physically Connected to Area 0
All areas of an OSPF network should have a physical connection to the backbone, but is some cases it
is not possible to physically connect a remote area to the backbone. In these cases, a virtual link is
configured to connect the remote area to the backbone. A virtual path is a logical path between two
border routers that have a common area, with one border router connected to the backbone.
Partitioning the Backbone
OSPF also allows virtual links to be configured to connect the parts of the backbone that are
discontinuous. This is the equivalent to linking different area 0s together using a logical path between
each area 0. Virtual links can also be added for redundancy to protect against a router failure. A virtual
link is configured between two border routers that both have a connection to their respective area 0s.
Neighbors
Routers that are connected to the same area or segment become neighbors in that area. Neighbors are
elected via the Hello protocol. IP multicast is used to send out Hello packets to other routers on the
segment. Routers become neighbors when they see themselves listed in a Hello packet sent by another
router on the same segment. In this way, two-way communication is guaranteed to be possible
between any two neighbor routers.
Any two routers must meet the following conditions before the become neighbors:
Area ID − Two routers having a common segment − their interfaces have to belong to the
•
same area on that segment. Of course, the interfaces should belong to the same subnet and
have the same subnet mask.
Authentication − OSPF allows for the configuration of a password for a specific area. Two
•
routers on the same segment and belonging to the same area must also have the same OSPF
password before they can become neighbors.
Hello and Dead Intervals − The Hello interval specifies the length of time, in seconds,
•
between the hello packets that a router sends on an OSPF interface. The dead interval is the
number of seconds that a router's Hello packets have not been seen before its neighbors
declare the OSPF router down. OSPF routers exchange Hello packets on each segment in
order to acknowledge each other's existence on a segment and to elect a Designated Router
on multi-access segments. OSPF requires these intervals to be exactly the same between any
two neighbors. If any of these intervals are different, these routers will not become neighbors
on a particular segment.
Stub Area Flag − Any two routers also have to have the same stub area flag in their Hello
•
packets in order to become neighbors.
Adjacencies
Adjacent routers go beyond the simple Hello exchange and participate in the link-state database
exchange process. OSPF elects one router as the Designated Router (DR) and a second router as the
Backup Designated Router (BDR) on each multi-access segment (the BDR is a backup in case of a DR
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
119