Link Aggregation - D-Link xStack DES-3800 Series User Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
and in determining the state of the link aggregation group. If two redundant link aggregation groups
are configured on the Switch, STP will block one entire group; in the same way STP will block a
single port that has a redundant link.

Link Aggregation

To configure port trunking, click on the Link Aggregation hyperlink in the Trunking folder under
Administration to bring up the following window:
Figure 7- 10. Port Link Aggregation Group window
To configure port trunk groups, click the Add button to add a new trunk group and use the Link
Aggregation Group Configuation window (see example below) to set up trunk groups. To modify a
port trunk group, click the Hyperlinked Group ID. To delete a port trunk group, click the
corresponding X under the Delete heading in the Current Link Aggregation Group Entries table.
Figure 7- 11. Link Aggregation Settings window – Add
80