Ospf Authentication - D-Link xStack DES-3800 Series User Manual

Network Link-State Updates – Issued by multi-access areas that have more than one attached
•
router. One router is elected as the Designated Router (DR) and this router issues the network
link-state updates describing every router on the segment.
External Link-State Updates – Issued by an Autonomous System Border Router and
•
describes routes to destinations outside the AS or a default route to the outside AS.
The format of these link-state updates is described in more detail below.
Router link-state updates are flooded to all routers in the current area. These updates describe the
destinations reachable through all of the router's interfaces.
Summary link-state updates are generated by Border Routers to distribute routing information about
other networks within the AS. Normally, all Summary link-state updates are forwarded to the
backbone (area 0) and are then forwarded to all other areas in the network. Border Routers also have
the responsibility of distributing routing information from the Autonomous System Border Router in
order for routers in the network to get and maintain routes to other Autonomous Systems.
Network link-state updates are generated by a router elected as the Designated Router on a multi-
access segment (with more than one attached router). These updates describe all of the routers on the
segment and their network connections.
External link-state updates carry routing information to networks outside the Autonomous System.
The Autonomous System Border Router is responsible for generating and distributing these updates.

OSPF Authentication

OSPF packets can be authenticated as coming from trusted routers by the use of predefined passwords.
The default for routers is to use not authentication.
There are two other authentication methods − simple password authentication (key) and Message
Digest authentication (MD-5).
Message Digest Authentication (MD-5)
MD-5 authentication is a cryptographic method. A key and a key-ID are configured on each router.
The router then uses an algorithm to generate a mathematical "message digest" that is derived from the
OSPF packet, the key and the key-ID. This message digest (a number) is then appended to the packet.
The key is not exchanged over the wire and a non-decreasing sequence number is included to prevent
replay attacks.
Simple Password Authentication
A password (or key) can be configured on a per-area basis. Routers in the same area that participate in
the routing domain must be configured with the same key. This method is possibly vulnerable to
passive attacks where a link analyzer is used to obtain the password.
Backbone and Area 0
OSPF limits the number of link-state updates required between routers by defining areas within which
a given router operates. When more than one area is configured, one area is designated as area 0 − also
called the backbone.
The backbone is at the center of all other areas − all areas of the network have a physical (or virtual)
connection to the backbone through a router. OSPF allows routing information to be distributed by
forwarding it into area 0, from which the information can be forwarded to all other areas (and all other
routers) on the network.
In situations where an area is required, but is not possible to provide a physical connection to the
backbone, a virtual link can be configured.
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
118