xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
Install the Switch in a site free from strong electromagnetic field generators (such as motors),
•
vibration, dust, and direct exposure to sunlight.
When installing the Switch on a level surface, attach the rubber feet to the bottom of the
•
device. The rubber feet cushion the Switch, protect the casing from scratches and prevent it
from scratching other surfaces.
Installing the Switch Without the Rack
When installing the Switch on a desktop or shelf, the rubber feet included with the Switch should first
be attached. Attach these cushioning feet on the bottom at each corner of the device. Allow enough
ventilation space between the Switch and any other objects in the vicinity.
Figure 2 - 1. Prepare Switch for installation on a desktop or shelf
Installing the Switch in a Rack
The Switch can be mounted in a standard 19" rack. Use the following diagrams to guide you.
Fasten the mounting brackets to the Switch using the screws provided. With the brackets attached
securely, you can mount the Switch in a standard rack as shown in Figure 2-3 below.
Mounting the Switch in a Standard 19" Rack
CAUTION: Installing systems in a rack without the front and side stabilizers installed
could cause the rack to tip over, potentially resulting in bodily injury under certain
circumstances. Therefore, always install the stabilizers before installing components in
the rack. After installing components in a rack, do not pull more than one component
Rubber Feet
Figure 2 - 2. Fasten mounting brackets to Switch
9