GE LPS-O Instruction Manual page 261

12 ASCII COMMUNICATIONS
Table 12–3: ASCII COMMAND LIST
ASCII Command Description
Command
Mnemonic
TIMe Displays the current LPS-
O time
LINEs Changes the number of
lines the relay will display
before pausing for the user
to read
GEModem Changes communications
type to GE-Modem after
user has logged out
ECHo Toggles the echo state and
reports its status
PORTparam Changes and displays the
current port parameters for
the LPS-O serial
communications port
END Ends the session
GE Power Management
(Sheet 6 of 7)
Lowest Relay Prompt
Level
Password
Needed
SETTINGS Do you want to change time? (Y/N):
Enter new time (hh:mm:ss):
Command is executed
VIEW Enter the number of LINES PER PAGE (24/25/48/
50):
SETTINGS
VIEW Echo is turned ON (OFF)
SETTINGS Do you want to change communication port
parameters? (Y/N):
Interface is (0 - RS232, 1 - RS485): 0
Enter Interface Type (0 - RS232, 1 - RS485):
Baud rate is 9600
Enter baud rate (19200, 9600, 4800, 2400, 1200,
300):
Parity check type is (0 -none, 1 - odd, 2 - even): 0
Enter parity check type (0 -none, 1 - odd, 2 - even):
Number of stop bits is 1
Enter number of stop bits (1 or 2):
Save changes? (Y/N):
VIEW
LPS-O Line Protection Relay
12.1 INTRODUCTION
User Response
Enter letter Y or
N; 6 digit time
code
Enter 24, 25, 48,
or 50
None
None
Y displays
parameter to be
changed, N
exits; 0 for
RS233, 1 for
RS485; press
ENTER for no
change; choose
baud rate
matching PC
port; Enter 0, 1,
or 2;
Enter 0, 1, or 2;
Enter Y or N
None
12-
7
12