Table of Contents
Advertisement
10 ALPS-TEST PROGRAM
•
The focus is set to the first item in the Menu contents list box.
•
The menu text is in the Menu text box.
•
The Command line text box has the invalid path name.
Change the path name to the correct path. Click on the OK button. Pull down the Tools menu and click on the
tool.
•
Verify that the program started.
Select the Setup menu item again. Add a second tool.
•
Verify that the tool gets added after the first tool.
Click on the OK button. Pull down the Tools menu.
Verify the following:
•
There are two tools and they are in the correct order.
•
The two tools are followed by a separator bar and the Setup menu item.
Select the Setup menu item again. Leave the first item in the Menu contents list box selected. Add a third
tool.
Verify that the tool gets added after the first tool and before the second tool.
Click on the OK button. Pull down the Tools menu.
•
There are three tools and they are in the correct order.
•
The three tools are followed by a separator bar and the Setup menu item.
To Remove a tool, select the Setup menu item again. Select the second item in the Menu contents list box.
Click on the Remove button.
•
Verify that the selected item gets removed from the Menu contents list box and that the item immediately
below the one removed is selected.
Click on the OK button. Pull down the Tools menu.
•
Verify that there are two tools and they are in the correct order.
•
The two tools are followed by a separator bar and the Setup menu item.
GE Power Management
LPS-O Line Protection System
10.6 TOOLS MENU
10
10-
15
Advertisement
Table of Contents
