GE LPS-O Instruction Manual page 193

8 LOCAL USER INTERFACE
This command can be used to trigger the immediate collection of oscillography data. Oscillography can be trig-
gered without at any privilege level. The user will be prompted to start the trigger.
Table 8–2: KEYPAD / DISPLAY INTERFACE ERROR MESSAGES
Error Message
VAL OUT OF RANGE
SETT NUM INVALID
Y/N NOT ENTERED
REQUEST INVALID
CATEGORY INVALID
BKR NUM INVALID
DATE INVALID
TIME INVALID
FAULT # INVALID
REMOTE LINK ACT
LUI KEY ERROR
ACT INVALID NOW
GE Power Management
OSC SNAPSHOT
Trigger Osc?
Cause of Error
The setting value is either greater than the upper limit or less than the lower
limit.
The setting number is not valid.
A YES or NO response key was required, but the [1/Y] or [3/N] key was not
pressed.
A key was pressed that is not valid for a sequence; for example:
The [ENT] key is pressed to view events.
The _ key is pressed during entry of a settings value.
An incorrect category number was entered for an action or information item.
A breaker number other than 1 or 2 was entered.
The day, month, or year entry is invalid.
The hour, minute, or seconds entry is invalid.
An out of range fault number was entered.
The remote communication link is in use for actions or settings; local settings or
changes can't be done.
The LUI received an invalid key code from the keyboard (hardware error).
The current action is invalid because the setting's CRC code is in error.
LPS-O Line Protection System
8.2 INFORMATION
8.2.11 OSCILLOGRAPHY SNAPSHOT
8
8-
25