5.15
Changing the display unit % to A (ampere)/V (volt)
: Current/voltage display mode
• Function
These parameters are used to change the unit of monitor display.
% ⇔A (ampere)/V (volt)
Example of setting
During the operation of the VFAS1-2037PL (rated current 16.6A) at the rated load (100% load), units are displayed
as follows:
1) Display in percentage terms
[Parameter setting]
Title
Current/voltage unit selection
* The converts the following parameter settings:
• A display
Current monitor display
Setting of electronic thermal protection level 1/2/3/4 , , , , ,
DC braking current
Stall prevention level
• V display
Voltage monitor display
V/f 5-point setting
Note:Base frequency voltage is always displayed in the unit of V.
Output current:
100%
DC voltage:
100%
Function
:[%]
:[%] → A (ampere)/V (volt)
E-25
2) Display in amperes/volts
Adjustment range
, , , ,
E6581301
Output current:
16.6A
DC voltage:
200V
(Converted into
AC voltage)
Default setting
5