Setting Frequency Via External Contact Input (Up/Down Frequency Setting - Toshiba TOSVERT VF-AS1 Instruction Manual

[Setting of jog run setting terminal (S3-CC)]
Assign control terminal S3 ([14: preset speed 3] in default setting) as the jog run setting terminal.
Title

Note:During the jog run mode, there is LOW (low speed detection signal) output but no RCH (designated frequency
reach signal) output, and PID control does not work.
The figure below shows the relationship between the operation panel jog run mode and each of the other modes.
Pressing the MODE key, which will move the inverter through each of the modes.
Note:When the inverter is in operation (RUN Key lamp is lit) or when an operation command is issued (RUN Key lamp
is lit), the inverter cannot be switched to operation panel jog run mode.
6
6.11

Setting frequency via external contact input (Up/Down frequency setting)

 : Input from external contacts - Up response time
 : Input from external contacts - Up frequency step
 : Input from external contacts - Down response time
 : Input from external contacts - Down frequency step
 : Initial Up/Down frequency
 : Initial Up/Down frequency rewriting
• Function
These parameters are used to set the output frequency by means of a contact signal from the external
control device.
[Parameter setting]
Title






These functions are operative when parameter  (frequency setting mode selection 1) is set to 10 or
parameter  (frequency setting mode selection 2) is set to 10 .
Function
Input terminal function selection 7 (S3)
MODE
Status monitor mode
MODE
Function
Input from external contacts - Up response time
Input from external contacts - Up frequency step
Input from external contacts - Down response time
Input from external contacts - Down frequency step
Initial Up/Down frequency
Initial Up/Down frequency rewriting
Adjustment range
~
Status monitor mode
Operation panel
jog run mode
Adjustment range
 ~[s]
 ~  [Hz]
 ~ [s]
 ~  [Hz]
~ [Hz]
:Not changed
:Setting of 
changed when power
is turned off.
F-20
E6581301
Setting value
 (Jog run setting terminal)
MODE
Status monitor mode
MODE
Default setting





