Toshiba TOSVERT VF-AS1 Instruction Manual page 57

Example of operation panel control
Key operated
ENT
RUN
STOP
3
Selecting a stop mode with the operation panel
In addition to deceleration stop by pressing
the following two stop modes.
Stop mode
Coast stop
Emergency stop
(from the
operation panel in
modes other than
the panel
operation mode)
LED display
The running frequency is displayed. (When standard monitor display

selection = [Operation frequency])
Set the operation frequency.

Press the ENTER key to save the operation frequency. and the
⇔
frequency are displayed alternately.
Pressing the RUN key causes the motor to accelerate to the set
⇔=
frequency in the specified acceleration time.
Pressing the
=
even during operation.
Pressing the STOP key reduces the frequency and causes the motor to
=⇔=
decelerate to a stop.
STOP
Action
In this mode, power This stop mode is enabled only in modes where the operation panel
supply from the can be used for operation.
inverter to the motor To enable the coast stop mode, set the parameter =.
⇒ For more details, refer to Section 6.36.6.
is shut off
instantaneously, *Default setting:= (Deceleration stop)
which causes the
motor to coast stop.
A stop mode can be In modes other than the operation panel operation mode, you can
selected from among: stop the motor (emergency stop) by entering a command from the
･Coast stop operation panel. (To quickly stop the motor in the operation panel
operation mode, set the parameter  to this mode.)
･Deceleration
ramp() Pressing the STOP key on the panel twice enables emergency
･Emergency DC stop.
braking (1) Press the STOP key.
･Deceleration ramp "" starts blinking.
() (2) Press the STOP key again.
Note: Default (Emergency stop)= to , the motor makes an emergency
setting:= stop (or trips) according to the setting. "e" will be displayed and a
(Coast stop) failure detection signal generated (FL activated). Select the output
terminal function 134 (135) to deactivate FL.
To clear "," press any key other than the STOP key while
"" is being displayed.
⇒ For more details, refer to Section 6.33.3.
*Default setting:= (Coast stop)
- Warning -
The emergency stop function is designed to forcefully stop the
motor by pressing the Stop key on the operation panel in
modes other than the operation panel control mode.
The emergency stop function cannot be disabled by any
setting. Every emergency stop is memorized as a trip in the
trip history record.
C-8
Operation
key or the key will change the operation frequency
key (in the specified deceleration time), the operating panel has
Operation, setting, etc.
E6581301