Changing The Display Unit % To A (Ampere)/V (Volt - Toshiba Tosvert VF-AS1 Instruction Manual

5.15

Changing the display unit % to A (ampere)/V (volt)

  : Current/voltage unit selection
• Function
These parameters are used to change the unit of monitor display.
% A (ampere)/V (volt)
Current 100% = Inverter's rated current
200V-class voltage 100% = 200Vac
400V-class voltage 100% = 400Vac
 Example of setting
During the operation of the VFAS1-2037PL (rated current 16.6A) at the rated load (100% load), units are displayed
as follows:
1) Display in percentage terms

5

[Parameter setting]
Title

* The  converts the following parameter settings:
• A display
• V display
Note: Base frequency voltage 1~4 (, , , ) is always displayed in the unit of V.

Output current:
100%

DC voltage:
100%
Function
Current/voltage unit selection
Current monitor display
Setting of electronic thermal protection level 1/2/3/4 , , , , 
DC braking current
Stall prevention level
Voltage monitor display
V/f 5-point setting
2) Display in amperes/volts


Adjustment range
: %
 : %  A (ampere)/V (volt)



, , , , 
E-26
E6581442
Output current:
16.6A
DC voltage:
200V
(Converted into
AC voltage)
Default setting
