Nortel CallPilot Installation And Configuration Manual page 51

May 2000
3 Remove the two screws on the right side of the Option 11 backplane, as
shown in the following illustration.
Result: The Option 11 backplane looks similar to the following picture:
4 Guide the connector of the intermediate SCSI cable (NTRH1407) up
through the bottom right side of the card cage.
5 Connect this connector to the recessed SCSI connector on the 200i server
faceplate.
Part 2: 200i Server Hardware Installation
Installing the server, cables, and peripheral devices
Temporarily remove these cables.
Remove these two screws.
51