Nortel CallPilot Installation And Configuration Manual page 69

May 2000
To connect the CD-ROM and tape drives
You can connect either the CD-ROM or tape drive to the intermediate SCSI
cable that you connected to the 200i server faceplate earlier. For complete
cabling diagrams, see the following sections:


"Option 11 and CD-ROM and tape drive cabling" on page 70


"Meridian 1 and CD-ROM and tape drive cabling" on page 71
1 Before you can connect the CD-ROM or tape drive, you must do the
following tasks:
a. Install the intermediate SCSI cable. See
b. Set the SCSI ID and termination settings. See
2
Once you have completed the above tasks, connect the CD-ROM or tape
drive to the switch as follows:
On the
Option 11
Meridian 1
Part 2: 200i Server Hardware Installation
SCSI cable" on page
for connection" on page
Do the following

CD-ROM drive: Connect the NTAK1305 SCSI cable
from the CD-ROM to the SCSI connector located on the
intermediate SCSI cable bracket assembly on the
Option 11.

Tape drive: Attach the A0769312 SCSI adapter to the
tape drive. Then connect the NTAK1305 SCSI cable
from the adapter to the SCSI connector located on the
intermediate SCSI cable bracket assembly on the
Option 11.

CD-ROM drive: Connect the CD-ROM drive to the
NTRH1409 cable you connected earlier to the
Meridian 1 I/O panel.

Tape drive: Attach the A0769312 SCSI adapter to the
tape drive. Then connect the SCSI adapter to the
NTRH1409 cable you connected earlier to the
Meridian 1 I/O panel.
Installing the server, cables, and peripheral devices
50.
57.
"Connecting the intermediate
"Preparing SCSI devices
69