Peripheral Connectivity - Nortel CallPilot Installation And Configuration Manual

May 2000

Peripheral connectivity

Introduction
Peripheral equipment is attached to the 200i server in two locations:


the server faceplate


the external I/O breakout panel
Faceplate connections
ATTENTION
The following peripheral devices are connected to the faceplate:


monitor (SVGA)


keyboard


mouse


PC card


MPC card (permanent)


SCSI cable (permanent)
Monitor, keyboard, and mouse
You need the monitor, keyboard, and mouse to install the operating system on
the 200i server. The monitor is always hot-pluggable. If the keyboard and mouse
are attached during bootup, then the keyboard and mouse are hot-pluggable.
That is, you can disconnect them after you finish configuring CallPilot and
reconnect them later if needed for server maintenance.
Part 2: 200i Server Hardware Installation
Connections made to the faceplate (with the exceptions
noted below) are temporary only, since you must remove
the cabinet cover to make these connections. The system
does not meet specifications for radiated EMI if you
remove the cabinet cover.
About the 200i server
35