Connecting Peripheral Devices To The 200I Server - Nortel CallPilot Installation And Configuration Manual

May 2000
Connecting peripheral devices to the 200i
server
Introduction
Continue installing the 200i server by adding all appropriate peripheral devices
before securing the 200i server to the backplane.
Connection of peripheral devices consists of the following mini-procedures:
1. Connect the intermediate SCSI cable. See
SCSI cable" on page
2. Set the SCSI ID and termination setting for each SCSI device that will be
connected. See
3. Set the DIP switches on the external fax modem. See
modem for connection" on page
4. Connect the peripheral devices to the 200i server. See the following
procedures:


"To connect peripherals to the faceplate" on page 68


"To connect the CD-ROM and tape drives" on page 69
5. Connect the peripheral devices to the I/O breakout panel. See the following
procedures:


"To connect peripherals to the I/O breakout panel" on page 71


"To connect the modem" on page 75
Part 2: 200i Server Hardware Installation
Installing the server, cables, and peripheral devices
50.
"Preparing SCSI devices for connection" on page
64.
"Connecting the intermediate
"Preparing the
57.
67