When Access Key Does Not Operate Properly - Subaru Legacy Outback 2008 Owner's Manual

7-16
Starting and operating
er immediately.
CAUTION
AT vehicles
Do not stop the engine while the
selector lever is in a position other
than the "P" position.
If the engine is stopped while the
selector lever is in a position other
than the "P" position, the power will
be in "Acc". If the vehicle is left in
this condition, the battery may be
discharged.
NOTE
By pressing the push-button ignition
switch for 3 seconds or longer during
driving, the engine can be stopped. Do
not stop the engine during driving
except in an emergency.
& When access key does not
operate properly
If the engine start procedures cannot be
operated because of strong radio noise in
the surrounding area or low battery of the
access key, try the following to start the
engine. When the battery of the access
key is discharged, replace it with a new
one.
! Starting engine when access key
does not operate properly (MT
vehicles)
When operating in a location with strong
radio noise, or when the battery of the
access key is low, the power can be
switched to "ON" and the engine can be
started by the push-button ignition switch
in the following procedures.
! Switching power to "ON"
1. Make sure that the parking brake is
engaged.
2. Make sure that the shift lever is in
neutral.
3. Depress the clutch pedal.
4. Hold the access key with the buttons
facing you, and touch the push-button
ignition switch with it.
When the communication between the
access key and the vehicle is completed,
a chime (ding) will sound, and the opera-
tion indicator on the push-button ignition
switch illuminates in green.
5. Within 5 seconds after the operation
indicator illuminates in green, release the
clutch pedal, and press the push-button
ignition switch.
! Starting engine
1. Make sure that the parking brake is
engaged.
2. Make sure that the shift lever is in
neutral.
3. Depress the brake pedal.
4. Depress the clutch pedal.