Subaru Legacy Outback 2008 Owner's Manual page 46

WARNING
Be sure to fasten both tongue plates
to the respective buckles. If the
seatbelt is used only as a shoulder
belt (with the connector's tongue
plate not fastened to the connec-
tor's buckle on the right-hand side),
it cannot properly restrain the wear-
er in position in an accident, possi-
bly resulting in serious injury or
death.
1. Remove the connector (tongue) plate
from the belt holder located at the front of
the recess by pulling the connector
(tongue) plate rearward.
2. Pull out the seatbelt slowly.
Seat, seatbelt and SRS airbags
3. After confirming that the webbing is not
twisted, insert the connector (tongue)
attached at the webbing end into the
buckle on the right-hand side until a click
is heard.
If the belt stops before reaching the
buckle, return the belt slightly and pull it
out more slowly. If the belt still cannot be
unlocked, let the belt retract slightly after
giving it a strong pull, then pull it out slowly
again.
– CONTINUED –
1-21