If A Battery Goes Dead; To Reset Double Locking System; Function Disabling Unlocking With Power Door Locking Switch (Australia Models Only) - Subaru Legacy Outback 2008 Owner's Manual

. Open the driver's window, then insert
the key into the key cylinder of the driver's
door and turn it in the unlocking direction.
. Break one of the windows and climb
out through the window opening.
& If a battery goes dead
If the double locking system cannot be
canceled because the vehicle battery or
transmitter battery has gone dead or
because of a blown fuse or other electrical
problem, insert the key into the key
cylinder of the driver's door and turn it in
the unlocking direction.
& To reset double locking sys-
tem
The double locking system must be reset
when the vehicle battery has been tem-
porarily disconnected for replacement or
charging. To reset the system, turn the key
once in the unlocking direction or press
the "OPEN" button on the transmitter. The
double locking system will then operate
normally.
Function disabling unlocking
with power door locking
switch (Australia models
only)
WARNING
Never lock the doors using the
keyless entry system while passen-
gers are inside the vehicle. Doing so
activates the function that disables
unlocking with the power door lock-
ing switch and so people in the
vehicle would not be able to open
the doors from the inside. This
could result in serious injury or
death.
Australia models are fitted with an anti-
theft function that disables door unlocking
with the power door locking switch. This
function is activated in the following
situations, disabling the doors from being
unlocked using the power door locking
switch, refer to the "Remote keyless entry
system" section in this chapter:
. The doors are locked using the remote
keyless entry system.
. The automatic locking function is in
operation.
Keys and doors
This function is canceled when the doors
are unlocked using the remote keyless
entry system or the ignition switch is
turned to "ON".
NOTE
. Even while this function is activated,
doors can be unlocked using their lock
levers, refer to the "Door locks" section
in this chapter.
. This function is not activated when
the doors are locked using the key or
power door locking switch.
2-31