Front Position Light; Front Turn Signal Light; Front Fog Light (If Equipped); Rear Combination Lights - Subaru Legacy Outback 2008 Owner's Manual

Table of Contents

Advertisement

11-64
Maintenance and service
& Front position light
It may be difficult to replace the bulbs. We
recommend that you have your SUBARU
dealer replace the bulbs if necessary.
& Front turn signal light
It may be difficult to replace the bulbs. We
recommend that you have your SUBARU
dealer replace the bulbs if necessary.
& Front fog light (if equipped)
It may be difficult to replace the bulbs. We
recommend that you have your SUBARU
dealer replace the bulbs if necessary.
& Rear combination lights
! Sedan
1. Use a screwdriver to give the knob at
the top of the rear combination light cover
a quarter of a turn clockwise or counter-
clockwise. Push the knob at the bottom of
the cover to open the cover.
1)
Rear turn signal light and hazard light
2)
Back-up light
3)
Tail light and Stop light
2. Remove the bulb holder from the rear
combination light assembly by turning it
counterclockwise.
3. Pull the bulb out of the bulb holder and
replace it with a new one.
4. Set the bulb holder into the rear
combination light assembly and turn it
clockwise until it locks.
5. Securely lock the cover against the
trunk trim by using the screwdriver to turn
the top knob clockwise.

Advertisement

Table of Contents
loading

Table of Contents