Ricoh Pro C5200 Series Manual page 30

CIP Training Pro C5200 series
Adjustment Settings for Operators
In [Special Mode], the replacement cycle of the cleaning unit for the PCU is shorter because of the
increased amount of lubricant that is applied.
If you reset the counter after replacing the cleaning unit for the PCU, [Special Mode] is reset to its factory
setting.
[Special Mode Selection: Black]
[Special Mode Selection: Cyan]
[Special Mode Selection: Magenta]
[Special Mode Selection: Yellow]
0210: [Smooth Fusing Belt]
Remove vertical and horizontal lines from the printouts.
Vertical or horizontal lines may appear when printing on paper that is larger than the paper used
immediately before it.
In such case, press [OK] to cause a roller to press on the fusing belt and prevent vertical and horizontal
lines. Select [For Belt Scratches] if vertical or horizontal lines appear on the edges of the paper. Select
[For Uneven Gloss (Short Time)] if there are patches of uneven glossiness.
[For Belt Scratches]
[For Uneven Gloss (Short Time)]
0211: [Fusing Ability by Feed Speed]
Specify appropriately to improve transferability to thick paper.
[Paper Feed Speed Mode]
0212: [Slope for Envelope Nip Width]
Adjust the slope for nip width between the fusing belt and the pressure roller when an envelope is being
fed.
Setting Items
Setting Items
Setting Items
Values
[Default]
[Special Mode]
Values
Press [OK].
Values
[Standard]
[Thick Paper Priority]
Default Value
[Default]
Default Value
[Standard]