Ricoh Pro C5200 Series Manual page 127

CIP Training Pro C5200 series
Adjustment Settings for Operators
Setting Items
[Textured Paper Mode Voltage: FC: Side
1]
036: [Textured Paper Mode Voltage: FC: Side 2]
Adjust the paper transfer voltage applied to Side 1 when printing in full color with Textured Paper mode
enabled.
Setting Items
[Textured Paper Mode Voltage: FC: Side
2]
Fuser Adjustment
050: [Fusing Temp]
Adjust the heat roller temperature.
• Decreasing the temperature too much may cause the toner to not properly fuse to the paper (cold
offset).
• Increasing the temperature too much may distort the paper and cause glossy lines, paper jams,
and insufficient toner fusing (hot offset).
• Depending on the type of paper, you can increase the toner gloss by increasing the temperature
by 5 to 10°C over the initial factory setting.
Setting Items
[Fusing Temp]
051: [Fusing Pressure Roller Temp]
Adjust the pressure roller temperature.
Max. Value Min. Value
14.0 0.0
Max. Value Min. Value
14.0 0.0
Max. Value Min. Value
200 100
Step Unit
0.1 KV
Step Unit
0.1 KV
Step Unit
1 degree(s)