Ricoh Pro C5200 Series Manual page 128

CIP Training Pro C5200 series
Adjustment Settings for Operators
• Decreasing the temperature too much may cause the toner to not properly fuse to the paper. (cold
offset).
Setting Items
[Fusing Pressure Roller Temp]
052: [Fusing Nip Width Setting]
Adjust the nip width between the fusing belt and pressure roller.
• Changing this setting may lead to insufficient fusing, which may cause the toner to unfuse from the
paper (cold offset).
Setting Items
[Fusing Nip Width Setting]
053: [Fusing Temp to Feed Ppr]
Adjust the fusing temperature at which to allow paper feeding after warming up.
Paper feeding starts when the fusing unit reaches the temperature defined by the selected mode. Select
one of the following modes:
1. This is the normal printing mode.
2. This mode reduces excessive luster or hot offset when printing on thin paper just after printing on
thick paper.
3. This mode reduces fusing errors by increasing the fusing temperature at which paper feeding is
allowed.
4. This mode reduces paper jams in the fusing pressure roller by decreasing the temperature of the
fusing pressure roller at which paper feeding is allowed.
5. This mode cannot be used on this machine.
6. This mode cannot be used on this machine.
Setting Items
[Fusing Temp to Feed Ppr]
Max. Value Min. Value
200 50
Max. Value Min. Value
3 1
Max. Value Min. Value
6 1
Step Unit
1 degree(s)
Step Unit
1 None
Step Unit
1 None