APRILIA SHIVER 900 Service Station Manual page 104

Electrical system
TABLE D4 - SADDLE SUPPORT ZONE
•
Position the secondary fuses (8), cou-
pling the rubber support to the tabs
present on the saddle support.
•
fasten the branch of the main wiring
harness (9) using two clamps (10). Po-
sition the ABS fuse (11) and the re-
programming connector (12) in the
respective housings.
TABLE D5 - SADDLE SUPPORT ZONE
•
After positioning the relay on its base
and connecting it, bend the cables that
leave the connector by 90° in order to
create an "S", as illustrated.
TABLE D6 - SADDLE SUPPORT ZONE
•
After fastening the plastic cover that
hides the various connections, check
that the "Red White" starter relay ca-
bles are not in contact with the plastic
at the point indicated.
ELE SYS - 104
SHIVER 900