APRILIA SHIVER 900 Service Station Manual page 224

Engine
Pos. Description
5 Flywheel side clutch control support /
half-crankcase fastening screw
Based on the engine design development, there are two types of clutch crankcases, associated to the
specific water pumps.
The second generation cover is distinguished through punch marks, as indicated in the image.
CAUTION
THE CLUTCH CRANKCASES MUST BE COUPLED TO THE CORRESPONDING WATER PUMPS.
THE COMPONENTS ARE NOT INTERCHANGEABLE.
THE CRANKCASE WITH THE PUNCH MARKS MUST BE COUPLED TO THE WATER PUMP WITH
PUNCH MARKS.
INCORRECT COUPLING MAY CAUSE SERIOUS DAMAGE TO THE ENGINE.
•
Unscrew and remove the retaining
screws.
•
Remove the clutch cover.
The removal of the clutch cover is recommended
for the replacement of the clutch discs. If the entire
clutch unit is removed, it is recommended to re-
move the clutch side crankcase.
However, the entire clutch unit can be removed,
by removing only the clutch cover. In this case,
perform the following operations:
•
measure the overhang of he clutch
housing from the crankcase, before re-
moval;
ENG - 224
Type Quantity
M6 2 13 Nm (9.59 lb ft)
SHIVER 900
Torque Notes
-