APRILIA SHIVER 900 Service Station Manual page 413

SHIVER 900
•
Access the right hand side of the mo-
torcycle and remove the three screws
(25) used to fasten the side panel
mounted on the filter box in order per-
mit the passage of the wiring harness.
NOTE
DURING REASSEMBLY, REPLACE THE CLAMPS IN THE
POSITIONS IDENTIFIED BY THE GREY TAPE.
•
Remove the side panel (26).
•
Insert a suitable screwdriver through
the hole in the side panel and loosen
the two clamps used fasten the throttle
body to the manifolds.
NOTE
DURING REASSEMBLY, MAKE SURE THAT THE METAL-
LIC CLAMPS ARE POSITIONED CORRECTLY SO AS TO
GUARANTEE THEY ARE TIGHTENED PROPERLY WHEN
REPOSITIONING THE THROTTLE BODY.
•
Disconnect the throttle body and re-
move the injector connectors (27).
CAUTION
THE FRONT INJECTOR CONNECTOR IS COLOURED
GREEN IN ORDER TO DISTINGUISH IT FROM THE REAR
CONNECTOR.
TAKE CARE NOT TO INVERT THE TWO CONNECTORS AS
THIS WOULD RESULT IN THE MOTORCYCLE NOT FUNC-
TIONING CORRECTLY, AS WELL AS GENERATING ELEC-
TRICAL ERRORS.
•
Remove the complete throttle body
(28).
•
Extract the internal wiring harness
through the side of the filter box.
•
Unclip the coil connectors (29) from their support on the base of the filter box, and disconnect
them.
Bodywork
BODYW - 413