APRILIA SHIVER 900 Service Station Manual page 99

SHIVER 900
TABLE P - FRONT LAMBDA PROBE
•
Connect the front lambda probe con-
nector (1) correctly, then fasten it to the
cable clamp pre-installed on the ABS
control unit support .
TABLE P1 - FRONT LAMBDA PROBE
•
Using a clip (2), fasten the lambda
probe wiring harness to the ABS con-
trol unit support.
TABLE P2 - FRONT LAMBDA PROBE
•
Using a clip (3), fasten the lambda
probe wiring harness (4) to the ABS
control unit support.
Electrical system
ELE SYS - 99