APRILIA SHIVER 900 Service Station Manual page 91

SHIVER 900
•
The main injection relay (4), fan control relay (5) and starter relay (6), which are located on
the left hand side of the filter box, must be secured to their respective fastening points using
the rubber supports.
TABLE D - STARTER MOTOR CABLE
•
The starter motor power supply cable
lug (1) must be fastened to the starter
motor using two electric washers (2)
and secured using serrated washer,
applying the pre-defined torque.
TABLE D1 - STARTER MOTOR CABLE
•
Cover the starter motor nut and the
square terminal using water-repellent,
dielectric grease.
•
If the starter motor cable is not routed
or fastened correctly, it may cause the
vehicle to catch fire.
TABLE E - OIL PRESSURE BULB
•
Check that the terminal is connected
and that the hood is inserted in the bulb
correctly, and apply a clamp so that
cap leg is bent by 180°, as illustrated.
Electrical system
ELE SYS - 91