APRILIA SHIVER 900 Service Station Manual page 106

Electrical system
TABLE A1 - ENGINE WIRING HARNESS ON
THROTTLE BODY AND FILTER BOX
•
Route the branch with the throttle body
connections through the lateral open-
ing.
TABLE A2 - ENGINE WIRING HARNESS ON
THROTTLE BODY AND FILTER BOX
•
Connect the front injector (3 - green)
and rear injector (4 - black) connectors.
TABLE A3 - ENGINE WIRING HARNESS ON
THROTTLE BODY AND FILTER BOX
•
After fastening the throttle body to the
base of the filter box, connect the cyl-
inder pressure sensors (5) and the
throttle body connectors (6).
CAUTION
THE FRONT THROTTLE BODY AND FRONT CYLINDER
PRESSURE SENSOR WIRING HARNESSES ARE MARKED
WITH THE INDICATION "FRONT", WHILE THE REAR
THROTTLE BODY AND REAR CYLINDER PRESSURE
SENSOR WIRING HARNESSES ARE MARKED WITH THE
INDICATION "REAR",
INVERTING THESE CONNECTORS WOULD RESULT IN
MOTORCYCLE MALFUNCTIONS.
TABLE A4 - ENGINE WIRING HARNESS ON
THROTTLE BODY AND FILTER BOX
•
Fasten the wiring harness to the throt-
tle bodies connection bracket inside
the filter box using two clamps (7), at
the points identified by the grey tape.
ELE SYS - 106
SHIVER 900