Eclipse 500 System Manual page 416

Section 15. Multi Function Display (MFD)
⎯
COM 1 & COM2
Selecting a communication radio (COM) for control is accomplished using
two keys labeled COM1 and COM2. When either COM 1 or COM 2 key is
pressed, a green light above the COM 1 or COM 2 key illuminates and the
selected communication radio becomes active. One communication radio is
selected at all times; this means that pressing the same key twice will have
no effect.
⎯
COM SEL
Pressing this key changes the highlighted cursor in the communication line
select key window between the COM1 standby frequency and the COM2
standby frequency The user may enter a new frequency at the cursor
position.
⎯
SWAP
Pressing this key exchanges the active frequency and standby frequency for
the communication radio, whose line select key window contains the
highlighted cursor.
⎯
MIN SET
Allows the pilot to edit the minimum altitude displayed in the MIN pre-select
window below the altimeter. To change altitude, press the MIN SET and
enter four digits using the keyboard, then press ENTER. This will set the
code in the CODE line select window.
⎯
SPARE/BLANK
This key is not currently assigned and pressing it has no effect.
⎯
MONITOR
Pressing this key sequentially steps through the available frequency monitor
sources including OFF.
⎯
SPKR
Pressing this key toggles the selected crew member's overhead speaker on
and off. The left keyboard controls the left Overhead Cockpit Speaker and
the right keyboard controls the right Overhead Cockpit Speaker.
396
Figure 279. Keyboard COM/NAV Group
Copyright © — Eclipse Aviation Corporation
Eclipse 5OO Systems Manual
Version 2.0 April 2007