Eclipse 500 System Manual page 261

Section 10. Electrical
10. Describe in general terms the difference between a mechanical circuit
breaker and an electronic circuit breaker?
11. Electronic circuit breaker status may be viewed where?
a. They are displayed on every system's synoptic page for respective system
components.
b. On the ECB SYNOPTIC page.
c. On the electric system synoptic page
d. None of the above are correct
12. What is one examples of protection and/or detection that the Generator
control units provide?
13. ACS load shedding should automatically remove power to what system (s)
during single generator operation?
14. What type of batteries are installed on the Eclipse 500?
a. NiMh (Nickel Metal Hydride)
b. Maintenance-free lead acid
c. NiCad
d. Sealed gel batteries
15. Which battery is connected to the Hot Battery Bus?
a. Start Battery
b. Systems Battery
c. Aft Battery
d. No battery is attached to the Hot Battery Bus; External Power is used to
power this bus
16. What is the purpose of the BUS TIE CONTACTOR?
a. To isolate buses
b. To tie buses
c. To turn off the starter/generators
d. Both A and B are correct
e. None of the above are correct
17. Circuit protection is accomplished by:
a. Mechanical circuit breakers
b. Electronic circuit breakers
c. Contactors
d. Load shedding
e. All of the above are correct
Version 2.0 April 2007
Copyright © — Eclipse Aviation Corporation
Eclipse 5OO Systems Manual
241