Eclipse 500 System Manual page 408

Section 15. Multi Function Display (MFD)
SENSOR
The Sensor (SENSOR) synoptic page provides pilot selection of Air Data system
sources for the left and right PFDs as well as the standby ADI. This page also
provides a secondary input for the altimeter setting. The main display on the
SENSOR synoptic is two windows containing the source selection for the AHRS
and ADC for all three displays.
⎯
PFD AHRS SRC
The Attitude Heading Reference System source (AHRS SRC) line select key
allows selection of the AHRS source for the PFDs to AUTO, 1, or 2.
• AUTO
• 1
• 2
⎯
PFD ADC SRC
The Air Data Computer Source (ADC SRC) line select key allows selection of
the ADC source for the PFDs to AUTO, 1, or 2.
• AUTO
• 1
• 2
⎯
MFD AHRS/ADC SRC
Selection of the AHRS and ADC Source for the MFD ADI is not available. On
start-up, the AHRS source defaults to AHRS 2, and if installed AHRS 3, while
the ADC defaults to ADC 3.
388
In the AUTO mode, the ACS automatically uses AHRS 1 for the left PFD,
AHRS 2 for the right PFD, as well as the MFD ADI. In the event a third
AHRS is available, it is used as the primary source for the MFD ADI.
Should a failure of either primary AHRS source (1 or 2) occur, the off-side
PFD will automatically use the remaining operating AHRS.
Selection of 1 for the AHRS SRC manually sets both the left and right
PFD to uses AHRS 1.
Selection of 2 for the AHRS SRC manually sets both the left and right
PFD to uses AHRS 2.
In the AUTO mode, the ACS automatically uses ADC 1 for the left PFD,
ADC 2 for the right PFD, and ADC 3 for the MFD ADI. Should a failure of
either primary ADC source (1 or 2) occur, the off-side PFD will
automatically use the remaining operating ADC.
Selection of 1 for the ADC SRC manually sets both the left and right PFD
to uses ADC 1.
Selection of 2 for the ADC SRC manually sets both the left and right PFD
to uses ADC 2.
Copyright © — Eclipse Aviation Corporation
Eclipse 5OO Systems Manual
Version 2.0 April 2007