Eclipse 500 System Manual page 278

Section 11. Interior Lighting
11.9 Interior Lighting Review Questions
1. LED lights are used on the Eclipse 500 to:
a. Provide extended lighting system component life & redundancy by using
multiple strings of LEDs
b. Reduce drag
c. Save weight
d. Answers A & B are correct
2. What is the purpose of the Start Battery Contactor/ Lighting Controller?
3. Why are come interior lights on timers?
a. LEDs burn out very quickly and the timer is installed to prevent overuse of
LED lighting
b. To prevent excessive battery depletion while lights are being used on battery
power only.
c. For cosmetic purposes only
d. None of the above
4. The interior lighting system is divided into which two categories?
a. Forward & Aft
b. Upper & Lower
c. Right & Left
d. Cockpit & Cabin
5. Where is the switch for the foot well lighting located?
a. Under the left-pilot's armrest
b. On the center switch panel
c. There is no switch these lights are always on but and can only be dimmed
d. None of the above
6. Where is the map lighting control switch?
a. A rotary switch on the autopilot control panel
b. On the center switch panel
c. On the sidestick
d. None of the above
7. Where is the upper cabin wash lighting switch located?
a. On the overhead console
b. On the center switch panel
c. This lighting comes on automatically and there is no switch
d. Both A & B are correct
8. How is the baggage compartment lit?
258
Copyright © — Eclipse Aviation Corporation
Eclipse 5OO Systems Manual
Version 2.0 April 2007