Eclipse 500 System Manual page 394

Section 15. Multi Function Display (MFD)
TAKEOFF CONFIGURATION OK AND WARNING MESSAGES
T/O Config OK Status Message
The Takeoff Configuration OK (T/O CONFIG OK) Status message will be
annunciated to the flight crew after the following conditions have been satisfied.
1. Both engines running at idle RPM or above.
2. Flaps are properly set either in the UP or TO position.
3. All 3 trims are set in the green band.
4. OAT is properly entered on the OPS page with "MAN" depicted.
5. Parking brake released.
6. Door is properly latched.
CAUTION:
If the message is not annunciated to the flight crew prior to departure proceeding
with the takeoff is not approved.
The T/O CONFIG OK Status Message is automatically removed when the throttles
are advanced for takeoff.
T/O Config Warning Messages
If the throttle is advanced for takeoff when the airplane is not correctly configured, the
takeoff warning horn sounds and a red warning message is displayed showing the
configuration problem:
CONFIG ELEV TRIM.............................................. Elevator trim not in green band
CONFIG RUDDER TRIM ........................................ Rudder trim not in green band
CONFIG AILERON TRIM ......................................... Aileron trim not in green band
CONFIG PARKING BRAKE .....................................................Parking brake is set
CONFIG FLAP.............................................. Flaps extended beyond takeoff range
CONFIG ENG TEMP.............. Ambient temperature not entered on OPS synoptic
NOTE:
CONFIG FLAP warning will not appear for attempting takeoff with the flaps in the
UP position
374
Copyright © — Eclipse Aviation Corporation
Eclipse 5OO Systems Manual
Version 2.0 April 2007