Positioning Satellites; About Your Watch; Watch Settings - Polar Electro VANTAGE M2 User Manual

POSITIONING SATELLITES

Change the satellite navigation system your watch uses in addition to GPS. The setting is located on your watch in
General settings > Positioning satellites. You can choose GPS + GLONASS, GPS + Galileo or GPS + QZSS. The
default setting is GPS + GLONASS. These options give you the possibility to test different satellite navigation systems
and find out if they can give you improved performance in areas covered by them.
GPS + GLONASS
GLONASS is a Russian global satellite navigation system. It is the default setting as its global satellite visibility and
reliability is the best of these three, and in general we recommend using it.
GPS + Galileo
Galileo is a global navigation satellite system created by the European Union. It is still under development and is
estimated to be ready by the end of 2020.
GPS + QZSS
QZSS is a four-satellite regional time transfer system and a satellite-based augmentation system developed to enhance
GPS in the Asia-Oceania regions, with a focus on Japan.

ABOUT YOUR WATCH

Check the device ID of your watch, as well as the firmware version, HW model, A-GPS expiry date and the Vantage M2-
specific regulatory labels.
Restart your watch, turn it off or reset all data and settings on it.
Restart: If you experience problems with your watch, you can try restarting it. Restarting the watch will not delete any of
the settings or your personal data from the watch.
Turn off: Turn your watch off. To turn it back on press and hold the OK button.
Reset all data and settings: Reset the watch back to factory settings. This will erase all data and settings on your
watch.

WATCH SETTINGS

To view and edit your watch settings, go to Settings > Watch settings
In Watch settings you'll find:
•
Alarm
•
Watch face
25