Removing The 3Ra61/3Ra62 Compact Starter; Removing The Compact Starter From A Din Rail - Siemens SIRIUS 3RA6 System Manual

5.5.2

Removing the 3RA61/3RA62 compact starter

The sections below explain how to remove the SIRIUS 3RA6 compact starter from:
● A standard munting rail
● A level surface (screw fastening)
● The infeed system for 3RA6
5.5.2.1

Removing the compact starter from a DIN rail

Requirements
● The compact starter must be switched off (actuator set to
● The AS-i cables or AS-i mounting module must be removed.
Note
Disassemble the compact starter's main circuit terminals and control circuit terminals
before removing the compact starter. as this makes the process easier.
Procedure
Step
1
2
SIRIUS 3RA6 compact starter
System Manual, 08/2018, NEB560060102000/RS-AB/007
Instructions
Pull the device down until the lower half
can be pulled away from the standard
mounting rail.
Pull the lower half of the device away
from the standard muonting rail and lift
the device off its upper edge.
3RA61/3RA62 compact starter
OFF position).
Image
5.5 Installing/removal
69