Siemens SIRIUS 3RA6 System Manual page 243

Design
The representation below explains the operator controls and display elements of the
operator panel.
Table 7- 30 Design of the operator panel
(1) DEVICE LED
(2) FAULT LED
(3) SF button and SF LED
(4) LED 1 - 4
(5) SELECT button
(6) Manual Mode button and
LED
(7)
Button and LED
(8)
Button and LED
(9) Slot for enabling block
SIRIUS 3RA6 compact starter
System Manual, 08/2018, NEB560060102000/RS-AB/007
7.14 Operator panel for 3RA64/3RA65 compact starter with IO-Link
The DEVICE LED indicates whether the operator panel is ready to run:
- Green: Operator panel is ready.
- Red: Operator panel is not ready.
The FAULT LED indicates whether communication between the compact starter and
the operator panel is functioning properly:
- Red: No communication between motor starter and operator panel.
- Off: Communication between compact starter and operator panel functioning
properly.
You use the SF button to reset the selected compact starter following an overload
trip.
The SF LED shows a RED light if there is a general fault.
LEDs 1 to 4 indicate which compact starter has been selected:
- Yellow: Compact starter selected.
- Off: Compact starter not selected.
There is always only one compact starter selected.
If you press the SELECT button for less than 5 secs, you switch between compact
starter 1 to 4. Gaps in the configuration are skipped. The compact starter selected in
each case is indicated by LEDs 1 to 4.
If you press the SELECT button for more than 5 secs, you switch the entire compact
starter group between jog mode and continuous mode. The change to the operating
mode is confirmed by the "MANUAL MODE" LED flashing.
You isolate the individual compact starters for manual mode using the MANUAL
MODE button. Isolation of a compact starter is confirmed by the MANUAL MODE
LED flashing.
You use the button to drive the currently selected compact starter in direction of
rotation 1 (clockwise). The
You use the button to drive the currently selected compact starter in direction of
rotation 2 (counter-clockwise). The
Plug the enabling block into the slot to take control priority of the compact starters.
LED lights up to confirm this.
LED lights up to confirm this.
Accessories
243