3RA61/3RA62 compact starter
5.5 Installing/removal
5.5
Installing/removal
5.5.1
Installing the 3RA61/3RA62 compact starter
The sections below explain how to install the SIRIUS 3RA6 compact starter on:
● A standard mounting rail
● A level surface (screw fastening)
● The infeed system for 3RA6
5.5.1.1
Mounting the compact starter on a DIN rail
Requirements
● A 35-mm standard mounting rail in accordance with IEC / EN 60715 must be properly
secured at the installation location.
● Observe the information on minimum clearances in "Dimension drawings (Page 253)".
● Remove the transport lock before installation and commissioning:
Procedure
①
②
③
④
64
Place the back of the device onto the upper edge of the standard mounting rail.
Press the lower half of the device against the rail until you hear the device engage.
Release the actuator.
Remove the transport lock from the compact starter toward the front.
SIRIUS 3RA6 compact starter
System Manual, 08/2018, NEB560060102000/RS-AB/007