3RA64/3RA65 compact starter with IO-Link
6.3 Configuring
6.3.4
Configuring with the S7-PCT port configuration tool (stand-alone)
6.3.4.1
Application
Configuration is always done with the S7-PCT port configuration tool whenever no
SIMATIC CPU is available.
6.3.4.2
Basic procedure and prerequisites
Basic procedure when configuring IO-Link master and IO-Link devices with the S7-PCT port
configuration tool (stand-alone)
1. You configure the connected IO-Link devices with the
tool.
Requirements
● The
You can either install
Portal V12.0 or higher, or you can download it from the Internet
(http://support.automation.siemens.com/WW/view/en/37936752).
● IO-Link IODD files (IO Device Description) are installed in the
All current IODD files of the SIRIUS devices are available on the Internet
(http://support.automation.siemens.com/WW/view/en/29801139/133100).
IODD files for V1.0 and V1.1 are available for the combination of an IO-Link master and
an IO-Link device according to the IO-Link communication specification V1.1. You may
need IODD files according to the communication specification V1.0 when replacing
devices in existing installations.
Note
Configuring with S7-PCT stand-alone is not possible for the CPU versions of the ET 200.
104
S7-PCT
port configuration tool is installed on the PG/PC.
S7-PCT
together with STEP 7 V5.4 SP5 or higher or STEP 7 TIA
System Manual, 08/2018, NEB560060102000/RS-AB/007
S7-PCT V2.0
port configuration
S7-PCT
hardware catalog.
SIRIUS 3RA6 compact starter