Siemens SIRIUS 3RA6 System Manual page 249

Requirements when the compact starter is installed on a standard mounting rail or level surface
(screw fastening)
Hazardous voltage!
Will cause death or serious injury.
Before starting work, disconnect the system and the device from the power supply.
● The compact starter must be switched off (actuator set to
Requirements when the compact starter is installed on the infeed system for 3RA6
The good thing about removing the compact starter from the infeed system for 3RA6 is that
you do not need to disconnect the entire system from the power supply. The compact starter
can be removed from the infeed system while the system is live, but the starter must be
switched off.
NOTICE
Compact starter and infeed system material damage!
You can damage the compact starter and the infeed system if you insert the compact
starter into the infeed system for 3RA6 while the starter is switched on (actuator in the
READY position).
Make sure that the compact starter's actuator is set to the
the compact starter into the infeed system for 3RA6.
● The compact starter must be switched off (actuator set to
For additional information on removing the individual components, please refer to the
following chapters:
● "Removing the compact starter from a DIN rail (Page 69)"
● "Removing the compact starter from a level surface (screw fastening) (Page 70)"
● "Removing the compact starter from an infeed system for 3RA6 (Page 72)"
● "Installing/removal (Page 150)"
● "Disconnecting terminal blocks (Page 83)"
SIRIUS 3RA6 compact starter
System Manual, 08/2018, NEB560060102000/RS-AB/007
DANGER
8.3 Replacing the compact starter
OFF position).
OFF position before you insert
OFF position).
Service
249