Configuration - Siemens SIRIUS 3RA6 System Manual

6.3.4.3

Configuration

Configuring the IO-Link device with the S7-PCT port configuration tool
1. Start the
2. Create a new project or open an existing project as described in the online help.
3. Select a bus category (PROFIBUS DP/PROFINET IO).
4. Select an IO-Link master.
5. Select the IO-Link device in the component catalog of the
6. Drag the IO-Link device out of the component catalog to the required port of the IO-Link
master.
7. Load the configuration into the IO-Link master before parameterizing the IO-Link device.
8. Start by parameterizing the IO-Link device.
Additional information is available in the
Note
To be able to access the IO-Link master or an IO-Link device online, communication
between the ET 200 and the higher-level controller must be active (BF-LED on
ET 200 interface module is off).
SIRIUS 3RA6 compact starter
System Manual, 08/2018, NEB560060102000/RS-AB/007
S7-PCT
port configuration tool.
3RA64/3RA65 compact starter with IO-Link
S7-PCT
S7-PCT
online help.
6.3 Configuring
port configuration tool.
105