Clutch Switch
The clutch switch is normally open and closes when the
clutch pedal is depressed. The clutch switch is attached
to a bracket on the left side of the clutch bell housing (Fig.
6).
Test the switch by disconnecting the wiring connector
and connecting a continuity tester across the two termi-
nals. With the engine off, depress the clutch pedal com-
pletely – there should be an indication of continuity.
Release the clutch pedal – there should be no continuity.
For clutch switch adjustment procedure, see Clutch
Pedal Adjustment in Chapter 6 – Drive Train.
Brake Switch
The brake switch is normally open and closes when the
brake pedal is depressed. The closed switch allows a
current path to the stop light.
Test the switch by disconnecting the wiring connector
and connecting a continuity tester across the two termi-
nals. With the engine off, depress the brake pedal –
there should be an indication of continuity. Release the
brake pedal – there should be no continuity.
Electrical System
Page 8 – 8
1
Figure 6
1. Clutch switch
1
Figure 7
1. Brake switch
Workman 3000/4000 Series