Toro Workman 3000 Series Service Manual page 33

Removal (Fig. 8)
1. Put vehicle on a level surface and engage parking
brake. Stop the engine and remove key from ignition
switch. Allow engine to cool.
2. Raise or remove the bed or other attachment(s). If
bed is raised, place safety support on lift cylinder (see
Operator's Manual).
3. Remove air cleaner components as needed using
Figures 8 and 9 as guides.
Installation (Fig. 8)
IMPORTANT: Any leaks in the air filter system will
cause serious engine damage. Make sure daily that
all air cleaner components are in good condition
and are properly secured during reassembly.
1. Reassemble air cleaner system using Figures 8 and
9 as guides. Air cleaner hose (item 6) and air inlet hood
(item 5) should be positioned straight upward. The va-
cuator valve on the air cleaner assembly should be posi-
tioned downward.
2. Lower or install bed or attachment(s).
Workman 3200/4200
2
6
1. Plug
2. Upper housing
3. Element
Page 3 – 13
1
3
Figure 9
4. Gasket
5. Lower housing
6. Vacuator valve
Briggs/Daihatsu Gasoline Engine
4
5