Toro Workman 3000 Series Service Manual page 118

18.Install reverse shaft (Item 1). Rotate main shaft and
reverse shaft gears to mesh gears when installing.
19.On 4WD vehicles, install bearing to gear case (see
Item 2 of Fig. 92) and center plate. Install front drive shaft
and 41T gear to the gear case.
20.Install center plate:
A. Insert 2 dowel pins into transaxle case.
B. Apply silicone sealant onto mating surface of
center plate.
C. Position center plate to transaxle.
D. Install and tighten cap screws to a torque from
18.5 to 22 ft–lb (24.5 to 29.5 N–m).
E. Apply multi–purpose grease onto lips of oil seal,
then insert oil seal flush with face of housing.
F. Apply moly disulfide grease to spline of main
shaft for clutch disk hub.
Drive Train
BEARING
(CENTER PLATE)
Page 6 – 46
1
Figure 92
FRONT DRIVE
SHAFT
BEARING
(GEAR CASE)
41T GEAR
Figure 93
Figure 94
Workman 3000/4000 Series
2