7. Install PTO input shaft sub–assembly:
A. Insert shifter block (Item 9) onto pin of shift arm.
Apply moly disulfide grease onto both sides of block
before installing.
B. Put shift collar of PTO input shaft sub–assembly
(Item 3) on the shifter block.
C. Install gear (Item 7) with bushing and thrust wash
-
er (Item 6) onto input shaft after sliding the assembly
toward PTO shaft side. Apply moly disulfide grease
to bushing of gear and thrust washer before instal
-
ling.
D. Slide two (2) bearings (Items 5 and 4) onto input
shaft.
E. Install two (2) retaining rings (Items 2 and 1).
Workman 3000/4000 Series
3
4
Page 6 – 61
7
5
Figure 138
3
Figure 139
6
7
Figure 140
Moly disulfide
grease
Figure 141
Drive Train
6