Toro Workman 3000 Series Service Manual page 41

Disassembly (Fig. 17)
1. Remove throttle bracket components from engine as
needed using Figures 17, 18 and 19 as guides.
Assembly (Fig. 17)
1. Install removed throttle bracket components to en-
gine using Figures 17, 18 and 19 as guides.
2. If removed, attach governor spring to bellcrank on
throttle bracket and outer most slot in engine governor
lever (Fig. 20).
3. Lubricate bellcrank grease fitting after assembly.
4. Check engine speed (both idle and high idle) and ad-
just if necessary (see Engine Speed Adjustment in Ad-
justments section of this chapter)
5. After engine speed has been checked and adjusted,
check operation and adjustment of accelerator cable
(see Operator's Manual). If needed, adjust accelerator
cable.
Workman 3200/4200
NOT EQUIPPED WITH GOVERNOR
SPRING ADJUSTING ROD
6 2
5
1. Governor spring
2. Bellcrank
3. Engine governor lever
EQUIPPED WITH GOVERNOR
SPRING ADJUSTING ROD
2
5
1. Governor spring
2. Bellcrank
3. Engine governor lever
3
1. Engine governor lever
2. Governor spring
Rev. B
Page 3 – 21
3
1
Figure 18
4. High idle stop screw
5. Low idle stop screw
6. Return spring
6
4
3
1
(0.125" (3.2 mm)
Figure 19
4. High idle stop screw
5. Low idle stop screw
6. Spring adjusting rod
2
1
Figure 20
3. Spring mounting slot
Briggs/Daihatsu Gasoline Engine
4