Toro Workman 3000 Series Service Manual page 49

Removal (Fig. 4)
1. Park vehicle on a level surface, stop engine, engage
parking brake, and remove key from the ignition switch.
Allow engine to cool.
2. Raise or remove the bed or other attachment(s). If
bed is raised, place safety support on lift cylinder (see
Operator's Manual).
3. Lift and remove the radiator screen from front of ra-
diator.
CAUTION
Do not open radiator cap or drain coolant if the
radiator or engine is hot. Pressurized, hot cool-
ant can escape and cause burns.
Ethylene–glycol antifreeze is poisonous. Dis-
pose of coolant properly, or store it in a properly
labeled container away from children and pets.
4. Remove the radiator cap. Drain radiator into a suit-
able container using the radiator drain located on the
lower right corner of the radiator.
5. Disconnect upper and lower radiator hoses from the
radiator.
6. Disconnect reservoir hose (item 13) from the radiator
filler neck.
7. Detach fan shroud from the radiator by removing four
(4) cap screws, flat washers and lock nuts. Position
shroud away from radiator.
8. Remove four (4) cap screws and flange nuts that se-
cure the radiator to the frame. Pull radiator from the ve-
hicle.
9. Plug all radiator and hose openings to prevent con-
tamination.
Workman 3300–D/4300–D
Installation (Fig. 4)
1. Remove plugs from radiator and hoses placed dur-
ing the removal procedure.
2. Position radiator to the frame. Secure radiator to the
vehicle with four (4) cap screws and flange nuts.
3. Attach fan shroud to the radiator with four (4) cap
screws, flat washers and lock nuts. Make sure that clear-
ance exists between shroud and fan at all points.
4. Connect reservoir hose (item 11) to the radiator filler
neck.
5. Connect upper and lower hoses to the radiator.
6. Make sure radiator drain is closed. Fill radiator with
coolant (see Operator's Manual).
7. Install the radiator screen.
8. Lower or install bed or other attachment(s).
Page 4 – 7
Briggs/Daihatsu Diesel Engine