Toro Workman 3000 Series Service Manual page 120

23.Measure countershaft end play. Rotate one of the
axle shafts back and forth to take up all back lash. Rotat-
ing the shaft in one direction will pull the shaft and bear-
ing away from the snap ring. Rotate axle shaft in this
direction, then measure space between the snap ring
and shim (set) with a feeler gauge. Make sure shim (set)
is held against the bearing during the measurement.
End play should be 0.000 to 0.0039 in. (0.00 to 0.10 mm)
(Fig. 98).
IMPORTANT: If end play is too large, replace shim/
shim set (item 2) in steps 21 and 22 with thicker
shims to reduce endplay.
24.Insert sealing cap (Item 1) flush with face of housing.
Make sure not to insert sealing cap too far. Pay attention
to direction of sealing cap.
Drive Train Page 6 – 48
Figure 98
1
Figure 99
Workman 3000/4000 Series